Hvac Inspection-Tune Up Cooling (52 points)

Check Thermostat (Batteries, Temperature)
Check Return air filter
Check Condensate Drain
Check Condensate Pump*
Check Condensate Pan and fittings for leaks
Check Blower Wheel
Check Blower motor stability
Check Blower motor amp draw
Check Blower capacitor
Check Board fuse
Examine parts for visible wear
Check and secure all panels
Check blower control board*
Check air leaks around return and supply
Examine all electrical connections/tighten
Check unit disconnect switch
Check temperature across coil
Remove debris around outside unit
Check control wire
Check condenser unit leveling

Check wall cap lineset cover installation
Check low side copper refrigerant line insulation
Check condenser coil airflow/cleaning
Check Condenser fan motor stability
Check Condenser fan motor amp draw
Check condenser fan blades for vibration
Check reversing valve*
Check crankcase heater*
Check relays & contactors
Check capacitors
Check all safety devices/sensors
Test time delay
Check defrost assembly*
Test refrigeration metering device
Measure operating pressures with gauges
Check noise and vibration levels
Check compressor amp draw
Make final operation test
Explanation of tune-up results
Advise improvements as needed